The core FPC design rules are simple: keep plated holes out of the bend zone, route traces across the fold as continuous conductors, add teardrops at pads and vias, set coverlay openings back from the bend, and back connector and component areas with stiffeners. Follow them and a flex is both manufacturable and reliable.
Most flex problems trace back to a handful of layout decisions. These are the rules we check first on every design, before tooling, because fixing them on paper costs nothing and fixing them in production costs a run.
What are the FPC design rules for the bend zone?
- No plated holes in the bend. A via in the fold cracks after a few bends. Keep all holes in the static or stiffened areas.
- Route perpendicular to the fold. Traces should cross the bend line at 90 degrees as continuous conductors, with no width changes in the bend.
- Stagger and curve. Offset traces on opposite layers so they do not stack, and use curved corners rather than sharp ones.
The bend radius itself is set by the rules in bend radius and flex life.
Pads, teardrops and coverlay
Use teardrops where a trace meets a pad or via, so the junction is a gradual transition rather than a sharp step that concentrates stress. Set coverlay openings back from the bend and from pad edges, so solder does not wick under the film and stiffen the flex next to a joint. Anchor pads with the coverlay overlapping their edge, which resists lifting during soldering and handling. The same window rules apply when a shield film is grounded through the coverlay, as set out in our guide to EMI shield film on flex.
Stiffeners and connectors
Put stiffeners under connectors, under mounted components and at ZIF insertion areas, so those regions stay flat and rigid. A stiffener must stop short of the bend region, or the flex cannot fold. Match the stiffener material to the job, covered in our FPC materials guide, and remember that a design needing components on rigid areas plus a reliable fold is often better built as a rigid-flex PCB.
Send us the design early
The cheapest design review is the one before tooling. Send your Gerber or drawing and we will flag any of these issues against your stack-up and bend requirement, then build from an approved sample. See flexible PCB for the full capability.
From our flex line: The single change we request most on incoming designs is moving a via out of the bend zone; it is the most common reason a first flex sample fails our fold test.
What are the key FPC design rules?
Why put teardrops on flex pads?
Where should stiffeners go on a flex circuit?
Want a design review?
Send your Gerber or drawing. We flag manufacturability issues and reply with an indicative price in two working days.


